How To Replace A Maytag Dishwasher Door Spring

Maytag Whirlpool WPW10337934 W10337934 Dishwasher Door Spring NEW OEM from www.ebay.com

Introduction

Maytag dishwashers are built to last, but like any appliance, they can experience problems over time. One common issue is a broken door spring. If your dishwasher door won't stay closed or falls open too quickly, it may be time to replace the door spring. In this article, we'll walk you through the steps to replace a Maytag dishwasher door spring.

Tools and Materials

Before you begin, you'll need a few tools and materials. Here's what you'll need: • Replacement door spring • Screwdriver • Pliers • Safety goggles

Step 1: Safety First

Before you start working on your dishwasher, make sure to disconnect it from the power supply. This will prevent any electrical shocks or accidents while you're working on it. Also, wear safety goggles to protect your eyes from any debris that may fly up as you work.

Step 2: Remove the Access Panel

The first step in replacing your Maytag dishwasher door spring is to remove the access panel. This is located on the bottom of the dishwasher, and you'll need a screwdriver to remove the screws that hold it in place. Once you've removed the screws, gently pull the access panel away from the dishwasher.

Step 3: Remove the Broken Spring

Once you have access to the dishwasher's interior, locate the broken door spring. You'll need to use pliers to remove it from the dishwasher. Be careful not to damage any other parts while you're removing the spring.

Step 4: Install the New Spring

Now it's time to install the new door spring. Start by attaching one end of the spring to the dishwasher, using pliers to secure it in place. Then, attach the other end of the spring to the door itself. Make sure the spring is properly aligned and secured on both ends.

Step 5: Test the Door

Once you've installed the new door spring, it's important to test the door to make sure it's working properly. Gently lift the door and let it go. If it stays in place and doesn't fall open too quickly, you've successfully replaced the door spring.

Step 6: Reattach the Access Panel

After you've tested the door, it's time to reattach the access panel. Carefully line up the panel with the dishwasher, and use a screwdriver to reattach the screws that hold it in place.

Conclusion

Replacing a Maytag dishwasher door spring may seem like a daunting task, but with the right tools and a little patience, it's a job you can do yourself. Just remember to take your time, follow the steps outlined above, and always put safety first. With a new door spring in place, your dishwasher will be back to working like new in no time.

Location:

animalh002