How To Replace Door Seal On Kitchenaid Dishwasher

KitchenAid Dishwasher Repair How to replace the Door Seal YouTube from www.youtube.com

Introduction

If you're experiencing water leaks or noticed the dishwasher is not cleaning dishes as thoroughly as it used to, it's possible that the door seal on your KitchenAid dishwasher needs replacing. The door seal is responsible for keeping water and debris from leaking out of the dishwasher, and over time, wear and tear may cause it to deteriorate. In this article, we'll guide you through the steps on how to replace the door seal on your KitchenAid dishwasher.

Tools and Materials Needed

Before getting started, gather the following tools and materials:

Replacement door seal
Phillips screwdriver
Torx screwdriver
Pliers
Clean cloth

Step-by-Step Guide

Step 1: Turn Off the Power

Before beginning any repair work, always turn off the power to the dishwasher. Unplug the dishwasher from the power outlet, or switch off the circuit breaker that supplies power to the dishwasher.

Step 2: Remove the Top and Side Panels

Use a Phillips screwdriver to remove the screws that secure the top panel of the dishwasher. Once the top panel is removed, use a Torx screwdriver to remove the screws that secure the side panels.

Step 3: Remove the Old Door Seal

Locate the old door seal on the dishwasher. Carefully remove it by pulling it off from the channel. Use pliers if necessary to remove any remaining pieces of the old seal.

Step 4: Clean the Channel

Before installing the new door seal, clean the channel where the old seal was removed from. Use a clean cloth to wipe away any debris or residue.

Step 5: Install the New Door Seal

Install the new door seal by starting at the top-center of the dishwasher and pushing it into the channel. Work your way around the channel, pushing the seal in until it's fully installed.

Step 6: Reinstall the Side and Top Panels

Once the new door seal is installed, reattach the side and top panels. Secure them in place with the screws that were removed.

Step 7: Turn On the Power

Finally, turn on the power to the dishwasher by plugging it back in or switching on the circuit breaker. Test the dishwasher to make sure it's working as expected, and check for any leaks.

Conclusion

Replacing the door seal on your KitchenAid dishwasher is a simple repair that can be done in just a few steps. By following this guide, you'll be able to fix any leaks and ensure your dishwasher is functioning properly. Remember to always turn off the power before beginning any repair work, and use the right tools for the job.