Skip to content Skip to sidebar Skip to footer

How To Replace The Door Spring On Your Kitchenaid Dishwasher


Door Spring Replacement for KitchenAid Dishwashers YouTube
Door Spring Replacement for KitchenAid Dishwashers YouTube from www.youtube.com

Introduction

Is your Kitchenaid dishwasher door not closing properly? It could be due to a faulty door spring. In this tutorial, we will guide you through the steps to replace the door spring on your Kitchenaid dishwasher.

Step 1: Safety First

Before you begin any repair work, ensure your safety. Turn off the power supply to your dishwasher by unplugging it from the wall outlet or switching it off at the circuit breaker. Also, wear protective gloves to avoid any injuries.

Step 2: Remove the Toe Kick

Remove the toe kick panel located at the bottom of the dishwasher. You can do this by removing the screws or using a flathead screwdriver to pry it off gently.

Step 3: Locate the Door Spring

Locate the door spring on the left or right side of the dishwasher door. It will be attached to the door hinge and the frame of the dishwasher.

Step 4: Remove the Old Door Spring

Before removing the old door spring, take a picture of it with your phone or camera to help you remember how to attach the new one. Use pliers to remove the spring from the hinge and frame.

Step 5: Install the New Door Spring

Attach the new door spring by hooking it onto the hinge and frame. Use the picture you took earlier to ensure you attach it correctly.

Step 6: Test the Door

Test the door by opening and closing it a few times to ensure it is working correctly. If it is not, double-check the installation of the door spring.

Step 7: Replace the Toe Kick

Once you are satisfied that the door spring is installed correctly, replace the toe kick panel by screwing it back into place or snapping it back on.

Step 8: Turn on Power

Turn on the power supply to your dishwasher by plugging it back into the wall outlet or switching it back on at the circuit breaker.

Step 9: Run a Test Cycle

Run a test cycle on your dishwasher to ensure everything is working correctly.

Conclusion

Replacing the door spring on your Kitchenaid dishwasher is a simple task that can be completed in a few easy steps. By following these instructions, you can save money on repair costs and have your dishwasher working like new again. Remember to always prioritize safety when working with appliances.

Post a Comment for "How To Replace The Door Spring On Your Kitchenaid Dishwasher"